Hello everyone, and welcome to the new look Quorn Wagon & Wagon website. As the website wasn’t ready last week, this update will cover two weeks of work. The website took a liittle more work than initially expected but we’re really happy with how it came out.
Last weekend, we removed the holed vacuum cylinder from 3689 and took a look at the brake rigging as the handbrake was difficult to operate and the brakes did not release cleanly. Charlie and Oliver took charge on the wagon, oiling and working the brakes. Eventually as with the other Esso tanks we split apart the system and found the sticky link. Usually with these its a bolted link right up in the top of the underframe that usually misses lubrication. We got the bolt undone (a surprise in itself!) and manage to get the link down to take it back up the yard for cleaning.
While this was done, a 21 inch vacuum cylinder from stock was prepared to be fitted, with Ernie and James dressing the studs from the cylinder while Harry and Charlie cleaned the cylinder, piston and dome cover. All surfaces applicable got a coat of red oxide primer.
Speaking of red oxide primer, Mark, Oliver, Tom and Ernie coated the last sections of 3854’s barrel in red oxide, after first preparing the surface. Hopefully we can get undercoat on it, however I suspect we have lost painting weather for the year now.
Towards the end of Sunday we got the overhauled cylinder fitted to 3689, but lost the light before getting it connected up. I also measured up the tyre profiles for 3689, which mostly measured up as new.
On to this week then, Saturday was pretty much a wash out, with the yard under 3689 a pond meaning we couldn’t get working to reconnect the vacuum cylinder. In a gap in the rain, we got the cylinder from 3689 stripped apart, using the Volvo to press the piston out of the bore. Harry and Charlie started to clean down the cylinder in the shelter of the garage. This one is definitely a case of looking worse than it is, but there is still some distance to go on that cylinder, maybe might be an opportunity to crack out the soda blaster.
In the afternoon we looked in the van train for any spare 21″ domes as we have 2 in need of repair. we found a further one, so its possible that we can make 2 good ones out of 3 holey ones!
Sunday was a much better day, we started by shunting out the Lowfit, taking the opportunity of a clear middle road to use the Volvo to lift the cylinder out of the wagon. The cylinder in the Lowfit had been damaged by a load in the wagon, filled with water and had subsequently holed through.
To ease rebuilding an 18″ I took the opportunity to take a rolling ring piston rod to make it into a guide rod to use when lowering a piston back into a cylinder. I cut the eye off the end and then drilled a cross hole for a bar to tighten/loosen the rod. We used it, to great effect, on the replacement 18″ cylinder for the Lowfit. The piston behaved exactly as described in the overhaul spec which is encouraging!
Using the Volvo again to lower the overhauled cylinder into the wagon, it was bolted back into the wagon and reconnected ot he brake system. Unfortunately, when we tried to test the system we found a the north end of the train pipe under the headstock is a little more akin to brandy snap and was letting the vacuum out. Another winter job for the list.
Nick and Tom walked back down the yard and got 3689 ready to test after which the team went up to test the brakes, after they were knocked back a half hole on the adjuster as the block gap was too tight to spec.
Charlie looked at the release valve removed from 3689, which to be honest I thought was more use as an anchor for a dingy! Mark and Oliver also got stuck in selecting a valve to look at..
The test went well, and the system passed with flying colours. After which we put everything away and had a celebratory cup of tea!
Thanks for joining us, and do let me know what you think of the new website. Cheers, Ross!
Leave a Reply