08/11/26 – TC2, a tank and the Tube

Written by

in

Hello everyone and welcome to another update from Quorn. This week we’ve given Test Car 2 some love, Charlie has been making excellent progress in removing the adhesive from 1802 and the Tube has been measured up for wood and had more old paint removed and the bare metal primed.

Dave and I started looking at the air system on the Test Car, to try and find and clean out the rest of the contamination. After systematically stripping down select bits and using an endoscope to peer inside. Weirdly, we haven’t found much evidence of other contamination aside from in the lower air cylinder pipes. We used air to blow out the gauge lines and then the brake cylinder lines from the distributor pipe flange down. The brake supply reservoir looked to be in fair condition. We put the system back together but can’t do anything else until we get the seals for the brake cylinders.

Nick took a look at the guard’s doors on Test Car 2, adjusting the door frame and kick plate on the west side door then ensuring the doors on both sides of the guards office work.

Dave and I took a look at the east side slip end door, which was starting to bind on the floor. having checked there was no jack rust between the wooden floor and the chassis, drilled and bolted the floor back down

Charlie concentrated on removing the sticker adhesive on 1802, doing a good job on the east side getting all of the residue off and sanded. On Sunday he finish that off then made a start on the west side.

Tom, Mark, Daniel and Oliver carried on with the Tube wagon, after shunting it onto the centre road so the air hoses would reach. This time concentrating on the solebar and underframe then priming the areas taken back to bare metal.

Nick and I finished off the east side slip end door on the Test Car, after re-shimming the hinges, and fixing down the brass finishing strip. Nick then found an fixed down a new step board, and then gave it a coat of black paint.

Ernie busied himself on our little lathe, making an adaptor for the bottom of P4 distributors so that we can check the control reservoir pressure. The fitting in the bottom of the distributor is a BSF thread, however most common fittings are BSP! We had some questions on our spare distributor so we can now look into that.

Next weekend, we hear that the Esso tanks are running at the Last Hurrah so we’ll be excitedly keeping our eyes peeled for them running. Join us next weekend to see what else we get up to.

Comments

Leave a Reply